Akai FX SYSTEM M630 Operator's Manual page 3

What you should know to protect
yourself
@ Never touch the plug with wet hands
e Always pull the power cord out by its plug, never by its cord.
@ Only let a qualified professional repair or reassemble the
components. An inexperienced person might touch the in-
ternal parts and receive a serious shock.
@ Never put anything, especially metal into the componenis.
Protect the components too
@ Use a household AC power source only. Never use a DC
power source.
@ if water is spilled on the components, disconnect them and
call your dealer.
® Makesure thatthe components are well ventilated and away
from direct sunlight.
@ Toavoid damage to the internal circuits and the external sur-
face, keep the components away from heat (stoves, etc.).
@ Avoid using aerosol sprays near the components as this
could damage the finish or cause sudden ignition of the
spray.
@ To avoid damaging the finish, never use paint thinner or
other similar chemicals to clean the components.
@ Place the components on a flat and solid surface.
@ |fyou do not plan to use the components for along period of
time, disconnect the power cord.
Avoid moisture condensation
lf the temperature of the room where the stereo system is
placed is suddenly increased, or if the system is transported
from acold location to a warm one, condensation (tiny droplets
of water) may form on the CD player's laser pickup lens or the
cassette deck's transport section (Such as capstan and heads),
preventing correct playback. If excess condensation forms on
the compact disc or inside the CD player, operation of the CD
player will not resume until the condensation has had ample
time to dissipate. If condensation forms inside the cassette
deck, the tape will stick to the heads and be ruined, or it will not
be transported properly. In either case wait 30 minutes to one
hour before using the stereo system.
important
Transport locking plugs
The transport locking plugs lock the laser pickup to prevent
damage to it during transportation.
Before playback these locking plugs (located on the bottom of
the CD player) must be removed.
When transporting the CD player be sure to re-insert the trans-
port locking plugs (make sure that the compact disc has been
removed first).
Slot fo remove
Lock @ lal
™, remove
Lock @ \
In case of malfunction
A large amount of static electricity may cause this stereo
component system to malfunction or stop functioning
completely. In this case, the micro-processors must be re-
set to their initial operating mode as follows.
Tuner:
Press the RESET button on the rear of the tuner to reset the
micro-processor.
(PUSH)
Amplifier, cassette deck and CD player:
Unplug the power cord from your household AC outlet for
at least 30 seconds, then re-connect it.
Make Your Contribution to Protect the Environment
Used batteries with the ISO symbol for recycling
as well as small accumulators (rechargeable bat- _CAY
teries), mini-batteries (cells) and starter batteries vor)
should not be thrown into the garbage can.
Please leave them at an appropriate depot. All other
household batteries can be thrown out with the household
waste.
29-En
Conforme ALD.M. 13 APIRLE 1989 DIRETTIVA CEE/
87/308.
3B-It