Chapter 3: Connecting Cables To The Outdoor Access Points; Safety Notices; General - Enterasys WS-AP3765i Installation Manual

This chapter provides the following information about connecting cables to the WS-AP3765 and
WS-AP3767e access points.
For information about...

Safety Notices

WS-AP3765 / WS-AP3767e Cables and Connectors
Connecting the Cables
Safety Notices

General

Warning: FM, UL, ATEX
WARNING - Explosion Hazard – Substitution of components may impair suitability for Class I,
Division 2 or Zone 2.
Warning: Cat. Nos. EAP-Wx-yy-zx (Canadian installation only):
• TC cable type and manufacturer shall be specified: Listed (QPOR), Type JZ-604 TC
manufactured by Helukabel GmbH.
• The TC cable for the power supply must be installed in areas of industrial establishments that
are inaccessible to the public and in a manner that meets the requirements in Rule 12- 2202(2)
of the CEC: Installed in conduit, other suitable raceway, or direct buried, when not in cable tray.
Provided with mechanical protection where subject to damage either during or after
installation.Installed only where qualified persons service the installation.
Warning: FM, UL, ATEX
WARNING: DO NOT OPEN WHEN ENERGIZED.
Warning: Notices FM, ATEX
While operating or servicing the WS-AP3765 or WS-AP3767e in hazardous environments, you
must strictly follow the warning notices given below:
• WARNING: SUBSTITUTION OF COMPONENTS MAY IMPAIR SUITABILITY FOR DIVISION 2.
• WARNING: DO NOT DISCONNECT EQUIPMENT WHEN A FLAMMABLE OR COMBUSTIBLE
ATMOSPHERE IS PRESENT.
Connecting Cables to the
Outdoor Access Points
Enterasys Wireless Outdoor Access Points Installation Guide 3-1
3
Refer to page...
3-1
3-4
3-6