Chapter 2: Installing And Connecting The Access Point; Unpacking The Access Point - Enterasys RoamAbout RBT-1602 Installation Manual

Installing and Connecting the Access Point
For information about...

Unpacking the Access Point

Installation Requirements and Recommendations
Installing the Access Point
Connecting an Access Point to the Network
Verifying AP Health
Unpacking the Access Point
The shipping carton contains the following items:
• One access point
• Mounting kit:
–
–
–
–
–
–
–
• One documentation pack that includes quick mounting instructions and a registration card
(not shown)
Figure
Note: Before installing the RoamAbout Access Point, you might need to generate a network plan
and an AP work order with RASM. (See
One universal mounting bracket (attached to the AP)
One paper mounting template (used for marking cutting areas and screw holes)
One two‐piece 14.2‐mm (9/16‐inch) T‐bar clamp
One two‐piece 15.9‐mm (5/8‐inch) T‐bar clamp
One two‐piece 23.9‐mm (15/16‐inch) T‐bar clamp
Two #6 sheet metal screws and two drywall anchors
Three adhesive rubber feet
2‐1 shows the contents of the shipping carton.
"RASM Network Plan and Work
RBT-1602 and RBT-1602C Wireless Access Point Installation Guide 2-1
2
Refer to page...
2-1
2-2
2-2
2-25
2-26
Orders" on page 2-2.)