Culus Approval For Information Technology Equipment; Fcc - Enterasys WS-AP3765i Installation Manual

Outdoor access points
Table of Contents

Advertisement

Non Incendive / Class I / Zone 2 / Group IIC / T4

cULus Approval for Information Technology Equipment

cULus Listed I. T. E.
Underwriters Laboratories Inc. complying with
UL 60950-1 (Information Technology Equipment)
CSA C22.2 No. 60950-1-03

FCC

This device complies with Part 15 of the FCC Rules
Operation is subject to the following two conditions:
This device may not cause harmful interference, and
This device must accept any interference received, including interference that may cause
undesired operation.
IEEE802.11b or g operation of this product in the USA is firmware-limited to channels 1 through
11.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV technician for help.
This device has been designed to operate with the antennas listed in
page 4-4, and having a maximum gain of 10 dBi. Antennas not included in this list or having a
gain greater than 10 dBi are strictly prohibited for use with this device. The required antenna
impedance is 50 ohms.
This Transmitter Must Not Be Co-located or Operating in Conjunction with Any Other
Antenna or Transmitter.
Note: Changes or modifications made to this equipment not expressly approved by Enterasys, Inc.
may void the FCC authorization to operate this equipment.
Note: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance 20 cm
between the radiator and your body.
cULus Approval for Information Technology Equipment
Enterasys Wireless Outdoor Access Points Installation Guide 5-5
"External
Antennas" on

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ws-ap3765eWs-ap3767e

Table of Contents