Table of Contents
Advertisement
Figure 2-13
Screwing WS-AP3765 or WS-AP3767e to a Mounting Plate
To remove the AP:
1.
Loosen the screws between the AP and mounting plate.
2.
Using a screwdriver or similar tool, press down the two lugs on the lower edge of the
mounting plate (position C in
3.
Pull out the lower edge of the AP to the front and then release it from the two clips on the
mounting plate (position B in
Figure 2-12
on page 2-12) and release the AP from the recesses.
Figure 2-12
on page 2-12).
Enterasys Wireless Outdoor Access Points Installation Guide 2-13
Mounting with Mounting Bracket
Advertisement
Table of Contents
