Sony DCR-TRV6 Operating Instructions Manual page 75

Audio dubbing
(1) Insert the recorded tape into your camcorder.
(2) Set the POWER switch to VCR on your can:corder.
(3) Locate the recording start point by pressing I1_ on the Remote Commander.
Then press I I at the point where you want to start recording to set your
camcorder to the playback pause :::ode.
(4) Press AUDIO DUB on the Remote Commander. The green _ I I indicator
appears on the LCD screen or in the viewfinder.
(5) Press II on the camcorder or on the Remote Commander and start playing
back the audio you want to record at the same time.
The new sound is recorded in stereo 2 (ST2) during playback.
(6) Press • at the point where you want to stop recording.
AUDIO DUB
To play back the sound
Adjust the balance between the original sound (ST1) and the new sound (ST2) by
selecting AUDIO MIX in the men:, settings (p. 85).
VCR SET
RETURN
MENU] END
Five minutes after when you disconnect the power source or remove the battery pack,
the setting of AUDIO MIX rettuns to the original sotu'<] (ST1) only. Tile default setting
is original sound only.
75