Sony DCR-TRV6 Operating Instructions Manual page 130

Troubleshooting
Symptom Cause and/or Corrective Actions
The power does not turn oil.
• Tile hattery pack
is not installed, or is dead
or nearly
dead.
") Install a charged battery pack. (p. 10, 11)
• Tile AC power adaptor is not connected to a wall outlet.
÷ Connect the AC power adaptor to a wall ontlet. (p. 14)
Tile end search fimction does not •Tile tape was ejected after recolding when nsing a tape
work. witbont cassette memo1T. (p. 24, 27)
• Yon have not recorded on tile new cassette yet. (p. 24, 27)
The end search ftmction does not • Tile tape has a blank portion in the beginning o1"middle.
work correctly.
The hattery pack is quickly • Tile operating temperature is too low.
discharged. • Tile hatte W pack is not t\dly charged.
÷ Charge tile hatte W pack again. (p. 11)
• Tile hattel T pack is completely dead, and cannot be
recharged.
÷ Replace with a new battel T pack. (p. 10)
The hattery remaining indicator does • Yon have nsed tile hattery pack in an extremely hot o1"
not indicate tile correct time. cold environment t_ora long time.
• Tile hattel T pack is completely dead, and cannot be
recharged.
÷ Replace with a new battel T pack. (p. 10)
• Tile batte W is dead.
÷ Use a charged battel T pack. (p. 10, 11)
÷ Charge tile batte W pack t\flly again so that tile indication
on tile hattel T remaining indicator is correct.
Tile power goes off althongh the
battery remaining indicator indicates
that the battery pack has enongh
power to operate.
The cassette cannot be removed fl'om • Tile power source is disconnected.
the holder. ÷ Connect it fiunly. (p. 10, 14)
• Tile batte W is dead.
÷ Use a charged battery pack. (p. 10, 11)
The [] and A indicators flash and no • Moistme condensation has occurred.
ftmctions except for cassette ejection @ Remove tile cassette and leave your camcorder fbr at
work. least one honr to acclimatize. (p. 138)
(Ill indicator does not appear when •Tile gold plated connector of the tape is dirty o1" dusty.
using a tape with cassette memor> + Clean the gold plated connector. (p. 125)
Remaining tape indicator is not • Tile _ REMAIN is set to AUTO in tile menu settings.
displayed. + Set it to ON to always display tile remaining tape
indicator. (p. 85)
130