Sony DCR-TRV6 Operating Instructions Manual page 11

Step 1 Preparing the power supply
!!i!!i!iii!i i i ii iiiiiill i! i i i i i i i i i i i ii!! ! i i i i iiiiiiiiiiiiiiiii i iiii iii ! !ii! i i i iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
Use the battelTy" pack after charging it fbr yore camcorder.
Your camcorder operates only with the "InfoLITHIUM" batte W pack (M series).
(1) Open the DC IN jack cover, pulling tbe cover out a little and rotating. Connect
the AC power adaptor supplied witb your camcorder to the DC IN jack on
your camcorder with the plug's • mark facing tbe lens side.
(2) Connect the power cord to the AC power adaptor.
(3) Connect the power cord to the wall outlet.
(4) Set the POWER switch to OFF (CHG). Charging begins. The remaining battery
time is indicated in minutes on the display window.
When the remaining batte_T indicator changes to ,_, normal charge is completed. To
f\flly charge the batte W (full charge), leave the batte W pack attached for ahout one hour
af'.er normal charge is completed tmtil FULL appears in the display window. Frilly
charging the battery allows you to use the battery longer than usual.
2
After charging the battery pack
Disconnect the AC power adaptor fi'om the DC IN jack on yore camcorder.
Notes
• Prevent metallic objects fi'om coming into contact with the metal parts of the DC plug
of the AC power adaptor. This may cause a short circuit, damaging the AC power
adaptor.
• Keep the battery pack d W.
• When the batte W pack is not to be used for a long time, charge the battery pack once
f\flly and then use it tmtil it f\flly discharges again. Keep the battelTy" p ack in a cool
place.
Remaining battery time indicator
The remaining battery time you record with the viewfinder is displayed.
The remaining barrelT time indicator in the display window roughly indicates the
recording time with the viewfinder.
Battery pack
The battery pack is charged a little befbre it leaves the f_ctory.
11