Cutter Blade Exit Area; Sensors - Brady BradyPrinter S3700 User Manual

Cutter Blade Exit Area

This procedure cleans the cutter blade exit area and the exit chute.
To clean the exit chute, use a pre-moistened swab from the Brady Cleaning Kit PCK-6, then clean the
exit chute entrance and exit chute ramp.
Note: To reach all areas of the exit chute, you can close the enclosure cover and carefully tilt the
printer up on its side.

Sensors

Some sensors on the printer are susceptible to dust that results from cutting or printing. These sensors
located under two media guides. The media guides can be removed to display the sensors.
To clean the sensors:
1. First, remove the ribbon and label supply
from the printer. (See
Ribbon" on page 17
Labels" on page
2. Loosen the screw on the two left media
guides, then carefully lift the media guide up
to expose the sensors underneath.
3. Using a pre-moistened foam swab, gently
insert the swab under the media guides and
wipe the surface of the sensors. Do not
allow the alcohol to drip from the swab.
BradyPrinter S3700 User Manual
"Removing the
and "Removing the
19.)
Maintenance
Cleaning the Printer
97