Brady BradyPrinter S3700 User Manual page 118

Error/Severity
Expected color not found: xxx
Error 84
Media jammed at eject path.
Error 88
Printhead not aligned.
Error 89
For 15" Panel
Use monochrome ribbon.
For 8" Panel
Use 15 inch panel or monochrome
ribbon.
Error 91
Pinch roller is unable to engage
media.
Error 93
Storage space for print jobs is
getting low.
Error 95
The system could not read the
printer's Label Library file.
Error 97
BradyPrinter S3700 User Manual
Cause
The expected color panel not
detected. The printer timed out
searching for the correct color
panel. The memory cell indicates
the color is there but the system
can't find it.
Media is jammed at the label exit
chute.
Something is blocking the
printhead from engaging properly.
The inserted ribbon is
incompatible with the ribbon used
to create the label.
Something is blocking the pinch
roller from engaging properly with
the tape.
The number of print jobs is getting
close to exceeding the storage
limit.
The Label Library file is out of
date.
Troubleshooting
Corrective Action
Clean the color sensor by
following step 5 in Sensors on
page 97. If that does not clear the
error, then replace the ribbon.
If error persists, contact Technical
Support.
Clear the jam within the label exit
chute.
Open the cover and remove any
obstruction preventing the
printhead from engaging properly.
If the error persists, contact
Technical Support.
Install either a 15 inch panel or
monochrome ribbon depending on
the error message shown.
Open the cover and remove any
debris or obstructions that is
preventing the pinchroller from
engaging properly.
Wait for the current print job to
complete before sending the next
print job.
Import a new Label Library file.
See Updating Printer Label
Library Values on page 92.
109