Table of Contents
Advertisement
2 0 0 H o u r S e r v i c e
1
Clamp the end of the damper shaft into RockShox Rear Shock vise
Clamp the end of the damper shaft into RockShox Rear Shock vise
blocks (10 mm slot) lightly but tight enough that it does not slip in the
blocks (10 mm slot) lightly but tight enough that it does not slip in the
vise blocks.
vise blocks.
Overtightening the vise can permanently damage the damper shaft.
Do not overtighten the vise.
2
Remove the remote cable pinch bolt and cable pinch plate from the
Remove the remote cable pinch bolt and cable pinch plate from the
remote pulley.
remote pulley.
3
While holding the remote spring preloader in place, remove the remote
While holding the remote spring preloader in place, remove the remote
spring preloader limit screw from the eyelet/mount.
spring preloader limit screw from the eyelet/mount.
4
Slowly allow the remote spring and preloader to unwind while holding
Slowly allow the remote spring and preloader to unwind while holding
the preloader in with your thumb and the 4 mm hex wrench.
the preloader in with your thumb and the 4 mm hex wrench.
R e m o t e S p r i n g S e r v i c e
NOTICE
RockShox Rear Shock Vise Blocks (10 mm)
2 mm
1.5 mm
4 mm
4 mm
43
Remote Spring Service
Advertisement
Table of Contents
