Table of Contents
Advertisement
S I D L u x e I s o S t r u t S e r v i c e
Prior to servicing the rear shock, remove it from the bicycle frame according to the bicycle manufacturer's instructions.
Consult the frame manufacturer for any required spare parts, lubricants, tools, and procedures required to remove and install the rear shock from the
bicycle frame.
Use only 2024+ (A1) SIDLuxe IsoStrut spare parts and service kits with 2024+ (A1) SIDLuxe IsoStrut.
2020-2023 (A1) SIDLuxe and 2024+ (A2) SIDLuxe spare parts and service kits are NOT compatible with 2024+ (A1) SIDLuxe IsoStrut.
Before disassembly or service of any air system remove the air pressure from all air chambers and remove the air valve cores.
If your shock will not return to full extension, do not attempt to service or disassemble your shock. Attempting to service a shock that will not return
to full extension can cause severe and/or fatal injuries.
Always wear safety glasses and nitrile gloves when working with suspension fluid.
Place an oil pan on the floor underneath the area where you will be working on the shock.
When replacing seals and o-rings, use your fingers or a pick to remove
the seal or o-ring. Spray RockShox Suspension Cleaner on each part and
clean with a shop towel. Apply grease to the new seal or o-ring. Only use
RockShox Dynamic Seal Grease when servicing RockShox shocks.
Inspect each part for scratches. Do not scratch any sealing surfaces when
servicing your suspension. Scratches can cause leaks.
NOTICE
⚠ WARNI NG
SAFET Y I NSTRUC TI ON S
NOTICE
8
SIDLuxe IsoStrut Service
Advertisement
Table of Contents
