Table of Contents
Advertisement
18
Install a new remote pulley onto the end of the remote cam.
Install a new remote pulley onto the end of the remote cam.
Insert the limit screw into the remote pulley and the end of the remote
Insert the limit screw into the remote pulley and the end of the remote
cam. Thread the limit screw carefully into the remote cam and tighten
cam. Thread the limit screw carefully into the remote cam and tighten
the limit screw until it bottoms out and stops.
the limit screw until it bottoms out and stops.
Confirm the remote pulley is securely installed.
Confirm the remote pulley is securely installed.
Do not overtighten the limit screw. Overtightening can strip the
threads in the remote cam.
19
Hold the preloader pushed into the eyelet/mount.
Hold the preloader pushed into the eyelet/mount.
Rotate the preloader with the hex wrench clockwise approximately
Rotate the preloader with the hex wrench clockwise approximately
360 degrees. The limit screw hole in the preloader should be aligned
360 degrees. The limit screw hole in the preloader should be aligned
with the limit screw hole in the eyelet/mount.
with the limit screw hole in the eyelet/mount.
Insert the preloader limit screw into the eyelet/mount and thread it into
Insert the preloader limit screw into the eyelet/mount and thread it into
the preloader.
the preloader.
Tighten the limit screw until it is flush with the eyelet/mount.
Tighten the limit screw until it is flush with the eyelet/mount.
NOTICE
1.5 mm
1.5 mm
4 mm
1.5 mm
4 mm
1.5 mm
Limit screw stops
1.5 mm
Flush with eyelet
48
Remote Spring Service
Advertisement
Table of Contents
