Table of Contents
Advertisement
12
Apply a dab of grease to the tip of a 2 mm hex wrench to secure the
Apply a dab of grease to the tip of a 2 mm hex wrench to secure the
bleed screw.
bleed screw.
Install the bleed screw into the bleed port finger tight.
Install the bleed screw into the bleed port finger tight.
Tighten the bleed screw to the specified torque.
Tighten the bleed screw to the specified torque.
Wipe away excess oil around the sealhead.
Wipe away excess oil around the sealhead.
Do not overtighten the bleed set screw. Overtightening the bleed
screw can drive the nylon compression ball too far into the bleed
port which could damage the compression ball.
13
Thread the SIDLuxe Rear Shock Air Valve Adapter Tool (blue) onto
Thread the
a shock pump and thread the other end into the damper body air/
nitrogen fill port.
Pressurize the damper body to 500 psi / 34.5 bar.
If the proper fill equipment is available, nitrogen can be substituted
If the proper fill equipment is available, nitrogen can be substituted
for air.
for air.
Once the damper body has been pressurized, remove the air valve
Once the damper body has been pressurized, remove the air valve
adapter tool from the air valve port before removing it from the shock
adapter tool from the air valve port before removing it from the shock
pump.
pump.
Separating the pump from the adapter first will cause the shock
body to depressurize.
NOTICE
NOTICE
RockShox Dynamic Seal
2 mm
Grease
2 mm
0.56 N∙m (5 in-lb)
SIDLuxe Air Valve Adapter Tool (blue)
SIDLuxe Air Valve Adapter Tool (blue)
2 mm
Shock pump
500 psi / 34.5 bar
(600 psi max)
65
IFP Installation and Bleed
Advertisement
Table of Contents
