How To Drop The Feed Dog; Additional Presser Foot Clearance; Attaching And Removing Presser Feet; Ee Ceeceeeee - ELNA EnVision 8006 Instruction Manual

How to Drop the Feed Dog
The feed dog drops out of position for hoop
embroidery sewing and special sewing techniques:
free motion embroidery, button sewing, etc.
The feed dog must always be up for traditional
sewing. Locate the feed dog lever on the back of the
free arm. Slide the lever either to the right (down) or
to the left (up).
@ Raised position
@) Lowered position
Additional Presser Foot Clearance
You can raise the presser foot about 6.5 mm (1/4")
higher than the normal up position for easy removal
of the presser foot, to place heavy fabrics under the
presser foot, or when moving the hoop under presser
foot. Pull up the presser foot lever beyond the normal
up position.
@) Presser foot lever
Attaching and Removing Presser Feet
Press the red button on back of the shank. The
presser foot will drop off. Place the selected presser
foot so the pin on the foot lies just under the groove
of the shank. Lower the presser bar to attach the
foot.
@ Red button
® Groove
© Pin
Attaching and Removing the Shank
The shank is removed by turning the thumbscrew
counter-clockwise with the screwdriver.
@ Thumbscrew
When attaching, match the hole in the shank with the
hole in the presser bar. Put thumbscrew into hole.
Tighten thumbscrew by turning it clockwise.
Shank
@© Presser bar