Inserting The Bobbin - ELNA EnVision 8006 Instruction Manual

15
Inserting the Bobbin
Gently slide the bobbin cover plate release button to
the right and remove the cover plate. Lift out the
bobbin.
@ Bobbin cover plate release button
@ Bobbin cover plate
Place the bobbin in the bobbin case with the thread
running counterclockwise.
Guide the thread into notch A on the front side of the
bobbin case.
Hold the bobbin with your right hand and pull the
thread to the left, through the tension spring blades.
Continue pulling the thread lightly until the thread
slips into notch B.
Pull out about 15 cm (6") of thread.
Replace the bobbin cover plate.
Check the threading by referring to the chart shown
on the bobbin cover plate.