ELNA EnVision 8006 Instruction Manual page 35

Sensor Buttonholes (cont'd)
Attach the automatic buttonhole foot R. Make sure
the button opening is at the back of the foot when it is
attached.
Extend the button holder to the back and place the
button in it. Push the holder together tightly around
the button.
The size of the buttonhole is automatically set by
placing the button in the automatic buttonhole foot.
The button holder on the foot adjusts for a button up
to 2.5 cm (1") in diameter.
@) Button holder
Pull the buttonhole lever down as far as it will go.
@) Buttonhole lever
Place both threads to the left under the foot. Insert
the garment under the foot and lower the needle at
the starting point. Then lower the automatic
buttonhole foot.
@) Mark buttonhole placement
@ Starting point
Press the foot control until the machine completes
the buttonhole and stops by itself.
32