Machine Threading; Securing Fabric In Embroidery Hoop - ELNA EnVision 8006 Instruction Manual

40
Machine Threading
Monogram and large pattern embroidery require you
to use the P foot.
Thread the machine as described for traditional
sewing (see pages 14-17). The needle thread is
passed through the P foot hole and up to the front of
the thread cutter, which acts as the thread holder.
Leave 2 to 3 cm (1") thread tail dangling.
Securing Fabric in Embroidery Hoop
1. Use a washable fabric marker to mark reference
lines for embroidery position.
2. Loosen the screw on the outer hoop and remove
inner hoop.
3. Set the template inside the inner hoop.
NOTE: The L and R markings on the hoop should be
visible and at the bottom when setting in the
template.
4. Place the inner hoop/template on top of fabric and
stabilizer. Match the fabric reference lines with the
template. Complete this step on a flat surface for
accuracy.