ELNA EnVision 8006 Instruction Manual page 59

Troubleshooting (cont'd)
Condition
Seam puckering.
Type of
Sewing
All
All
All
Traditional
Traditional
Embroidery
Cause
. The needle thread tension is too tight.
. The needle thread or bobbin thread is not threaded properly.
he needle is too large for the fabric being sewn.
he stitch length is too long for the fabric.
The foot pressure dial is not adjusted correctly.
When sewing extremely lightweight materials,
place stabilizer underneath the fabric.
The fabric is not pulled taut in the embroidery hoop.
Slipping fabric.
The fabric is not
feeding smoothly.
Traditional
Traditional
Reference
See page 8.
See page 15-16.
See page 12.
See page 20.
See page 6.
See page 41.
The presser foot dial is not adjusted correctly.
. The correct presser foot is not being used.
Traditional
Traditional
Traditional
raditional
Traditional
Traditional
The machine
doesn't run.
Strange sound
occurs when
machine Is
switched on.
All
All
All
Traditional
Embroidery
All
All
. The feed dog is packed with lint.
The foot pressure dial is not adjusted correctly.
The stitches are too close.
he fabric is not fed when sewing begins.
The feed dog is lowered.
The correct presser foot is not used.
See page 6.
See computer
display.
See page 53-54.
See page 6.
See page 20.
See page 53-54.
See page 5.
See computer display.
The machine is not plugged in.
2. Athread is caught in the hook area.
3. The control circuit is not working correctly.
4. The start/stop key is only used for hoop embroidery sewing.
5. The foot control is only used for traditional sewing.
Stitches are
distorted.
All
All
Traditional
Traditional
Embroidery
Embroidery
Embroidery
Embroidery
Embroidery
1. Something is caught between the carriage and the machine.
2. The carriage is touching something around the machine.
1. The correct presser foot is not being used.
2. The needle thread tension is too tight.
3. The stitch length is not suitable for the fabric being sewn.
The fine adjustment dial is not set properly.
The embroidery hoop is not attached properly.
he carriage has bumped into something near the machine.
he fabric is not pulled taut in the embroidery hoop.
The end of the fabric is caught or being pulled when
sewing embroidery.
9. The needle thread on wrong side of fabric is not
cut correctly.
See page 13.
See page 53-54.
Turn machine off
and turn it on again.
See page 13.
See page 39.
Remove the object.
See page 39.
See computer display.
See page 8.
See page 20.
See page 4.
See page 41.
See page 39.
See page 41.
Stop machine and free
end of fabric.
Cut extra needle thread
on wrong side of fabric.
The automatic
buttonhole stitches
are not balanced.
Computer display
keys don't work.
Traditional
Traditional
Traditional
All
Embroidery
All
All
1. The stitch length is not suitable for the fabric being sewn.
2. Interfacing is not being used with fabrics.
3. There is a gap between the slider and spring holder.
1. The bobbin winder spindle is in the winding position.
2. The letter size and amount of characters are beyond the
capacity of hoop.
3. The control circuit is not working correctly.
4. Traditional sewing or hoop embroidery modes have not
been properly selected.
56
See page 20.
See page 31.
See page 34.
See page 14.
See page 44.
Turn machine off and
turn it on again.
See pages 18, 42
and 49.