ELNA EnVision 8006 Instruction Manual page 3

IMPORTANT SAFETY INSTRUCTIONS
Your Elna model 8006 sewing machine is designed and constructed for HOUSEHOLD use
only. Read all instructions before using this sewing machine.
DANGER — To reduce the risk of electrical
shock:
1. Your sewing machine should never be left
unattended when plugged in. Always unplug the
machine from the electrical outlet immediately after
using and before cleaning.
2. Always unplug before replacing light bulb. Replace
bulb with same type rated 13.2 Volts D.C. 3 watts.
3. Do not reach for the machine if it has fallen into
water. Unplug immediately.
4. Do not place or store machine where it can fall or be
pulled into a tub or sink. Do not place it in or drop it
into water or other liquid.
WARNING — To reduce the risk of burns, fire,
electrical shock or injury:
1. Do not allow the machine to be used as a toy.
Supervision is necessary when this machine is used
by or near children.
2. Use this machine only for its intended use as
described in this manual. Use only attachments
recommended by the manufacturer as described in
this manual.
3. Never operate this machine if it has a damaged cord
or plug, is not working properly, has been dropped or
damaged, or dropped into water. Return the machine
to the nearest authorized dealer or service center for
examination, repair, electrical or mechanical
adjustment.
4. This machine is equipped with a special connection
cord which, if damaged, must be replaced by an
identical cord. This can be obtained from your
dealer.
5.
10.
11.
12,
13.
14,
15.
16.
Never operate the machine with any air opening
blocked. Keep ventilation openings of the sewing
machine and foot control free from accumulation of
lint, dust and fibers.
. Never drop or insert any object into any opening.
. Do not use outdoors.
. Do not operate where aerosol (spray) products are
being used or where oxygen is being administered.
. To disconnect, turn machine off, then remove plug
from outlet.
Do not unplug by pulling on cord. To unplug, grasp
the plug, not the cord.
Keep fingers away from all moving parts. Special
care should be used around the sewing machine
needle.
Always use the proper needle plate. The wrong plate
can cause the needle to break.
Do not use bent needles.
Do not pull or push fabric while stitching. It may
deflect the needle causing it to break.
Switch the machine off when making any adjustment
in the needle area, such as threading needle,
changing needle, threading bobbin, changing
presser foot, etc.
Always unplug the sewing machine from the
electrical outlet when removing covers, lubricating or
when making any other servicing adjustments
mentioned in the instruction manual.
SAVE THESE INSTRUCTIONS
IMPORTANT
Be sure to keep machine away from static electricity, heat sources, humidity and direct sunlight. When
using your sewing machine the first few times, place waste fabric under the presser foot and run the
machine without thread for a few minutes. Wipe away excess oil.