Winding The Bobbin - ELNA EnVision 8006 Instruction Manual

—
itr
Winding the Bobbin
Lift up the spool pin. Place the spool of thread on the
spool pin with the thread coming off the spool as
shown. Attach the large spool holder and press it
firmly against the spool of thread. (The small spool
holder is used with narrow or small spools of thread.)
Slide the thread under the thread guide hook, around
the upper thread guide and the bobbin winder thread
guide. Pass the thread through the hole in the bobbin
from the inside to the outside. Place the bobbin on
the bobbin winder spindle and push it to the right.
@) Spool pin @ Bobbin winder
@ Spool of thread spindle
® Large spool holder Additional spool pin
@ Thread guide hook ie :
© Upper thread guide @ Additional spool pin
© Bobbin winder
thread guide
The additional spool pin may be used to wind an
extra bobbin without unthreading the machine.
Procedure — insert the spool stand and the additional
spool pin in the hole. Place the felt and spool on the
pin with the thread coming off the spool as shown.
Spool stand (4) Spool pin felt
NOTE: Spool holder needs to be changed according
to the type of thread spool.
A. Large spool
B. Small spool
C. Should the thread tangle around the
spool pin, use the spool stand.
The computer display screen will show a bobbin
winding. Holding the free end of the thread, press the
foot control. Stop the machine when it has made a
few turns and cut the thread close to the hole in the
bobbin. Press the foot control again. When the
bobbin is fully wound, it will stop automatically.
Return the bobbin winder to its original position by
moving the spindle to the left and cut the thread as
shown. The machine will not sew until the spindle is
moved to the left.