Table of Contents
Advertisement
About this task
Attention:
• Read
"Safety inspection checklist" on page iv
work safely.
• Touch the static-protective package that contains the component to any unpainted metal surface on the
server; then, remove it from the package and place it on a static-protective surface.
• Make sure the type of power supply is applicable to server drive configuration. See
page 2
for more information.
Watch the procedure
A video of this procedure is available at YouTube:
AU3iY3F7lq3qfqr5caGbIu
Procedure
Step 1.
Lower the power supply into the chassis, and slide it toward the opening on the rear side of chassis
until the release tab snaps into place.
Figure 103. Installing the power supply to the chassis
Step 2.
From outside of the chassis, fasten the four screws to secure the power supply unit to the chassis.
and
.
"Installation guidelines" on page 41
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
.
Chapter 3
Hardware replacement procedures
to ensure that you
"Specifications" on
133
Advertisement
Table of Contents
