A video of this procedure is available at YouTube:
AU3iY3F7lq3qfqr5caGbIu
Procedure
Step 1.
(Optional) If you are installing an intrusion switch option, assemble the intrusion switch. Insert the
intrusion switch into the bracket until it click into place.
Figure 81. Assembling the intrusion switch
Step 2.
Install the intrusion switch.
a.
Align the intrusion switch to the slot on the chassis.
b.
Fasten the screw to secure the intrusion switch to the chassis.
Figure 82. Installing the intrusion switch
Step 3.
Connect the intrusion switch cable to the system board, see
After you finish
.
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
"Internal cable routing" on page
.
Chapter 3
Hardware replacement procedures
19.
103