Table of Contents
Advertisement
Make sure the screw holes that are nearest to the drive connector are outside of the drive
retainer.
Figure 49. Drive screw hole placement on retainer
1
Screw holes nearest to the drive connector
After you finish
1. Install the optical drive cage, see
2. Connect the signal and power cable to the system board, see
3. Complete the parts replacement, see
4. Check the drive activity LED on the front panel to verify if the drives are operating correctly.
Table 29. Drive activity LED behavior
Status
Solid on
Off
5. Use the Lenovo XClarity Provisioning Manager Lite to configure the RAID if necessary. For more
information, see
https://sysmgt.lenovofiles.com/help/topic/LXPML/RAID_setup.html
Remove the drive cage (bay 3)
Follow this procedure to remove a simple-swap drive cage from bay 3.
ThinkSystem ST50 V2 Maintenance Manual
66
"Install the optical drive cage" on page
"Complete the parts replacement" on page
Description
Color
White
The drives are active.
None
The drives are not active.
78.
"Internal cable routing" on page
158.
.
19.
Advertisement
Table of Contents
