Table of Contents
Advertisement
Figure 59. Installing the optical drive bezel
Step 4.
Install the optical drive.
a.
From outside of the chassis, insert the optical drive into the chassis.
b.
Slide the optical drive inward until the latch snaps into place.
Figure 60. Installing the optical drive
Step 5.
Connect the signal and power cable to the system board, see
After you finish
1. Proceed to complete the parts replacement, see
Remove the optical drive cage
Follow this procedure to remove the optical drive cage.
ThinkSystem ST50 V2 Maintenance Manual
76
"Internal cable routing" on page
"Complete the parts replacement" on page
19.
158.
Advertisement
Table of Contents
