Table of Contents
Advertisement
Procedure
Note: To prevent from damaging the drive with static discharge, do not touch the circuit board on the
bottom of the drive.
Figure 37. Circuit board on the drive
Step 1.
Install a 3.5-inch or 2.5-inch drive to the retainer
a.
Slightly tear both sides of the retainer apart.
b.
Align the four holes on the drive with the corresponding pins on the retainer; then, fit the
drive into the retainer.
Note: The drive connectors should face the retainer handles.
Install a 3.5-inch drive into the retainer
ThinkSystem ST50 V2 Maintenance Manual
54
Advertisement
Table of Contents
