Table of Contents
Advertisement
About this task
Attention:
• Read
"Safety inspection checklist" on page iv
work safely.
• Turn off the server and peripheral devices, and disconnect the power cords and all external cables, see
"Power off the server" on page
• If the server is in a rack, remove it from the rack. See
• Remove any locking device that secures the server, such as a Kensington lock or a padlock.
• Place the server on its side with the cover up.
Watch the procedure
A video of this procedure is available at YouTube:
AU3iY3F7lq3qfqr5caGbIu
Procedure
Step 1.
Make preparation for this task.
a.
Remove the server cover, see
Note: The heat sink and processor could be very hot. To avoid burning yourself, wait for a few
minutes after turning off the server before you remove the server cover.
b.
Remove the front bezel, see
c.
Remove the front panel, see
Step 2.
Remove the power button with LED from the front panel.
a.
Press the release tab on the power button to release it from the front panel.
b.
Remove the power button from the front panel.
Figure 99. Removing the power button with LED
After you finish
1. Install a new power button, see
2. If you are instructed to return the component or optional device, follow all packaging instructions, and
use any packaging materials for shipping that are supplied to you.
and
9.
.
"Remove the server cover" on page
"Remove the front bezel" on page
"Remove the front panel" on page
"Install the power button with LED" on page
"Installation guidelines" on page 41
"Remove the server from the rails" on page
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
.
Chapter 3
Hardware replacement procedures
to ensure that you
138.
144.
84.
87.
128.
127
Advertisement
Table of Contents
