Processor Replacement (Trained Technician Only); Remove The Processor - Lenovo 7D8JA02GNA Maintenance Manual

Figure 104. Securing the power supply units to the chassis
Step 3. Connect the processor and system power cables to the system board, see
on page 19.
After you finish
1. Reinstall bay 1 drive cage and the 3.5-inch drive, see
replacement" on page
2. If applicable, reinstall bay 2 drive cage and the 2.5-inch drive, see
(bay 1-2) replacement" on page
3. Proceed to complete the parts replacement, see

Processor replacement (trained technician only)

Use the following procedures to remove and install a processor. This procedure must be executed by a
trained technician.
Attention: Before you begin replacing a processor, make sure that you have an alcohol cleaning pad (part
number 00MP352) and gray thermal grease (part number 41Y9292).
Remove the processor (trained technician only)
Follow this procedure to remove the processor. This procedure must be executed by a trained technician.
ThinkSystem ST50 V2 Maintenance Manual
134
50.
50.
"Simple-swap drive and drive cage (bay 1-2)
"Simple-swap drive and drive cage
"Complete the parts replacement" on page
"Internal cable routing"
158.