Thermador Pro Grand PRD364WDGU/C Use And Care Manual page 35

Issue
Warm air or steam escapes from
oven vent
Cooling fan runs even when the
oven is turned off
The general electrical system of
the appliance is not working.
The automatic ignition is not work-
ing.
The burner flame is not uniform.
The gas flow is not normal or there
is no gas.
There is a smell of gas in the
kitchen.
Cause and troubleshooting
It is normal to see or feel steam or warm air escaping from the oven vent
WARNING
Do not block or obstruct the flow of air through the ventilation openings. The vent is
located at the back of the appliance. The vent needs to be unobstructed and open
to provide necessary airflow that is important for proper performance.
▶ Do not touch the vent area while the appliance is on and for several minutes after
the appliance is off. Some parts of the vent and surrounding areas become hot
enough to cause burns. Allow appliance sufficient time to cool before touching or
cleaning vent areas.
▶ Do not position plastic or other heat-sensitive items on or near the vent. These
items could melt or ignite.
▶ To provide proper ventilation of the range do not remove range feet.
The cooling fan will continue to run, even after the oven has been turned off, until
the oven has cooled sufficiently
This is normal. There is no action required.
▶
The circuit breaker has tripped.
Check circuit breaker or fuse box to your house.
1.
Make sure there is proper electrical power to the appliance.
2.
The plug for the power cord is not plugged in.
Connect the appliance to the power supply.
▶
There has been a power failure.
Check whether the lighting in your kitchen or other appliances in the room are
▶
working.
Food remnants, dirt, or cleaning products are located between the igniters and the
burners.
Clean the space between the igniter and the burner.
▶
Burner parts are wet.
Carefully dry the burner parts.
▶
The burner parts are not positioned correctly.
Position the burner parts correctly.
▶
The appliance is not connected properly to the power supply.
Contact a qualified electrician.
▶
The burner parts are not positioned correctly.
Position the burner parts correctly.
▶
The grooves on the burner are dirty.
Clean the grooves on the burner.
▶
The gas supply is blocked by intermediate gas valves.
Open the gas valves.
▶
The gas cylinder is empty.
Replace the gas cylinder.
▶
A gas valve has been left on.
Turn off the gas taps.
▶
Incorrect coupling of gas cylinder.
Check the proper connection to the gas cylinder.
▶
The gas pipe to the appliance is leaking.
Shut off the gas supply at the main gas valve.
1.
Ventilate the premises.
2.
Immediately notify an authorised installation technician to check and certify the
3.
installation.
Troubleshooting en-us
35