Table of Contents
Advertisement
Automatically start scanning
Document handling
54
This option overrides the Auto Start option that is set in the TWAIN
Datasource, ISIS Driver and VRS. For more information see the Scanning
Setup Guides for TWAIN, ISIS, and VRS.
If this option is Off, the scanner will go into a paused mode and you can press
the Start/Resume button on the Operator Control Panel to start scanning.
Document handling allows you to select how the scanner transports
documents through the scanner. This affects how the documents are fed into
the scanner, how fast they move through the scanner, and how they are placed
in the output tray.
NOTE: This option is not available when Controlled Dual Stacking is enabled.
The options displayed on this screen are based on what is set up in your
scanning application for the current scan job. The options are: Normal,
Improved Stacking and Best Stacking, OR Thick, Thin and Fragile.
If the scanning application has specified one of these three options: Normal,
Improved Stacking or Best Stacking then only these three options will be
displayed on the screen (as shown above).
• Normal — no additional handling is performed. This option is best used
when all documents are similar in size. It is recommended that you use the
side guides and document stop when scanning in the Normal mode. Normal
mode is not available if Controlled Dual Stacking is enabled.
• Improved Stacking — aids in controlling how the documents are stacked/
ordered in the output tray for mixed document sets. This should work for
most mixed document sets.
• Best Stacking — when your document set contains a variety of sizes, this
option provides the best control of how the documents are stacked/ordered
in the output tray.
A-61868 November 2016
Advertisement
Table of Contents
