Scanning; Getting Your Scanner Ready To Scan; Adjusting The Input Elevator - Kodak i5 50 Series User Manual

3 Scanning

Getting your scanner
ready to scan
Adjusting the input
elevator
A-61868 November 2016
1. Be sure the scanner is on and in Ready mode (Power button LED is green
and constant).
2. Adjust the input elevator to meet your scanning needs. See "Adjusting the
input elevator" on page 17.
3. Adjust the output tray to meet your scanning needs. See "Adjusting the
output tray" on page 19.
4. Select your scanning application.
NOTE: The illustrations in this chapter show the i5250/i5650/i5250V/i5650V
Scanner. All adjustments are the same for the i5850/i5650S/i5850S
Scanners unless otherwise noted.
You can adjust the side guides and input elevator height to accommodate your
scanning needs. When the scanner is not in use, the input elevator can be
folded up against the scanner.
NOTE: The input elevator must be in the lowest position and the elevator side
guides must be folded down before closing it.
• Adjusting the side guides — the side guides can be adjusted for right-
edge, left-edge or center feeding. The side guides can be moved together
for center feeding or independently for offset feeding (right-edge or left-
edge). Before moving the side guides, be sure the locking switch is not in
the locked position (see below).
NOTE: When using the optional Enhanced Printer, documents should be
placed in the input elevator in a manner that will align the print
string in the proper location. See "4 Document Printing" on page 61
for more information.
• Locking the side guides — side guides may be locked into position after
they are adjusted. This is helpful when the placement of a print string is
important.
17