Servo Motor - Schwinn 170 Service Manual

5. Disconnect the Speed Sensor Cable (D) and
Power Inlet Cable (E) from the wiring harness (F).
6. Tie the length of string to the end of the lower
Pull the cable and string down through the hole (H)
at the base of the Mast so that the string extends
through the mast.
7.
Remove the zipties that attach the lower Console
8.
Using the needlenose pliers, unhook the Tension Spring
(J) from the Main Frame. Pull back and release the Magnet
Arm (K) enough to disengage it from the Motor Pulley Shaft
(L).
9.
Loosen and remove the two hex head bolts (M) from the
Servo Motor (C).
NOTICE: Hold the Servo Motor so that it does not fall.
10. Remove the Servo Motor (C). Discard the old Servo
Motor.
11. Installation is the reverse procedure. Adjust the new
Servo Motor to same position recorded in Step 3.
NOTICE: Do not touch the Potentiometer (N). Do not cut
or pinch any cables.
12. Tie the end of the string at the base of the Mast to the
Carefully pull the cable through the hole to the top of the
Mast mount. Untie the string and discard it.
H
A A
49
C
A
J
A
C
D
L
K
B