Schwinn 170 Service Manual page 17

NOTICE: This document provides instructions for the calibration of the Brake tension on the Schwinn
If you need assistance, please contact Customer Service (if purchased in US/Canada) or your local distributor (if purchased outside
This icon means a potentially hazardous situation which, if not avoided, could result in death or serious injury. Read and
understand all Warnings on this machine.
Nautilus, Inc., (800) NAUTILUS / (800) 628-8458, www.NautilusInc.com - Customer Service: North America (800) 605-3369, csnls@nautilus.com | outside U.S. www.nautilusinternational.com | © 2013 Nautilus, Inc. |
Schwinn is a trademark licensed to Nautilus, Inc., which is registered or otherwise protected by common law in the United States and other countries. |
Important Safety Instructions - Before servicing or using this equipment, obey the following warnings:
This icon means a potentially hazardous situation which, if not avoided, could result in death or serious injury. Read and understand all
Warnings on this machine.
Disconnect all power to the machine before you service it.
• Keep bystanders and children away from the product being serviced at all times.
• Some components of the equipment can be heavy or awkward. Enlist the service of a second person when you do maintenance steps involving these
components. Do not try to do heavy or awkward steps on your own.
• If replacement parts are necessary, use only genuine replacement parts and hardware supplied by Nautilus. Failure to use genuine replacement parts
can cause a risk to users, keep the machine from operating correctly and void the warranty.
• Be sure that all warning stickers and instructional placards applied to the product stay present and in good condition when doing maintenance or
replacing components. If at any time the Warning labels become loose, unreadable or dislodged, replace the labels. If purchased in US/Canada, contact
Customer Service for replacement labels. If purchased outside US/Canada, contact your local distributor for them.
• Do not try to change the design or functionality of the machine being serviced as this can adversely affect user safety.
performance.
SAVE THESE INSTRUCTIONS.
•
Tools Required (not included)
#2 Phillips screwdriver
Small flathead screwdriver
Pedal wrench or 15mm open end
wrench (130/230)
or crank puller (170)
2.5" x 10" cardboard (3mm / 1/8" thick)
and tape
Set the Brake Tension (Calibration) on the Schwinn
TM
130/170 and Journey 1.0/1.5 Bikes
130/170 and Journey 1.0/1.5 Upright Bikes.
™
ORIGINAL DOCUMENT - ENGLISH VERSION ONLY
7mm open end wrench
17
™ Replacement Procedure
Skill Level: III
8006749.030123.F