Schwinn 170 Service Manual page 40

5.
Remove the T-handle and washers that attach the
Handlebar to the Mast. Set them safely aside for reassembly.
NOTICE: Hold the Handlebar so that it does not fall.
6.
Remove the Handlebar and set it safely aside for
reassembly.
7. Bend the edges of the Top Shroud to disengage the
inside tabs from the Main Assembly, and slide the Mast
8.
pull the Mast out and disconnect the cables. Set the hard-
sembly. Discard the old Mast.
NOTICE: Do not cut or pinch the cables. This step may
require two people.
Note: Do not let the cables fall down inside the Frame.
9.
Install the replacement Console Mast, and the Mast
NOTICE: Make sure the Console Cable connector does
not fall into the Console Mast. Align the clips
on the cable connectors and make sure the
connectors lock. Do not cut or pinch Console
Cable. Be sure the tabs on the Top Shroud
snap into the Main Assembly.
-
40
X2