Schwinn 170 Service Manual page 34

12. Using a #2 Phillips Screwdriver, remove the 3 screws
that secure the Right Shroud. Remove the bottom screws
Shroud.
13. Installation is the reverse procedure. Put the Left Shroud
NOTICE: Be sure not to cut or pinch any cables. Be sure
the tabs in the Top Shroud snap into the Main
Assembly.
14. Final Inspection
Inspect your machine to ensure that all hardware is tight and
components are properly assembled.
Do not use until the machine has been fully assembled and
inspected for correct performance in accordance with the
Owner's Manual.
34