Servo Motor - Schwinn Journey 1.0 Service Manual

5. Disconnect the Speed Sensor Cable (D) and Power
Inlet Cable (E) from the wiring harness (F).
6. Tie the length of string to the end of the lower
Console Cable (G) at the top of the Mast mount. Pull the
cable and string down through the hole (H) at the base of
the Mast so that the string extends through the mast.
7. Untie the string from the Console Cable (G). Remove
the zipties that attach the lower Console Cable (G) to the
Frame.
8. Using the needlenose pliers, unhook the Tension Spring (J)
from the Main Frame. Pull back and release the Magnet Arm (K)
enough to disengage it from the Motor Pulley Shaft (L).
9. Loosen and remove the two hex head bolts (M) from the Servo
Motor (C).
NOTICE: Hold the Servo Motor so that it does not fall.
10. Remove the Servo Motor (C). Discard the old Servo Motor.
11. Installation is the reverse procedure. Adjust the new Servo
Motor to same position recorded in Step 3.
NOTICE: Do not touch the Potentiometer (N). Do not crimp any
cables.
12. Tie the end of the string at the base of the Mast to the end of
the Console Cable (G) on the new Servo Motor (C). Carefully pull
the cable through the hole to the top of the Mast mount. Untie the
string and discard it.
G
H
G
N
A
48
C
F
A
E
M
J
A
C
D
L
K
B