Console Mast - Schwinn 170 Service Manual

5. Remove the T-handle and washers that attach the Handlebar
to the Mast. Set them safely aside for reassembly.
NOTICE: Hold the Handlebar so that it does not fall.
6. Untie the string from the HR Cable. Remove the old Handlebar
and discard it.
7. Put the replacement Handlebar in the bracket, adjust the
Handlebar to the desired angle, and install the T-handle through the
holes.
NOTICE: Do not cut or pinch the cables.
8. Tie the end of the string under the Handlebar Bracket to the
end of the HR cable. Carefully pull the cable through the slot under
the Handlebar Bracket to the top of the mast. Fully tighten the
T-handle to keep the Handlebar in position. Push the cover into
position on the Handlebar Bracket.
NOTICE: Do not cut or pinch the cables. Do not let the cables
fall down in the Mast.
9. Connect the cables to the back of the Console and attach the
Console to the Mast.
NOTICE: Do not cut or pinch the cables.
10. Final Inspection
Inspect your machine to ensure that all hardware is tight and components
are properly assembled.
Do not use until the machine has been fully assembled
and inspected for correct performance in accordance
with the Owner's Manual.
37