Schwinn 170 Service Manual page 41

10. Put the Handlebar in the bracket, adjust the Handlebar to
the desired angle, and install the T-handle through the holes
and washers.
NOTICE: Do not cut or pinch the cables.
11. Use the pull cable in the Handlebar Bracket to route the
HR cable through the slot under the Handlebar Bracket to
the top of the mast. Fully tighten the T-handle to keep the
Handlebar in position. Push the cover into position on the
Handlebar Bracket.
NOTICE: Do not cut or pinch the cables. Do not let the
cables fall down in the Mast.
12. Connect the cables to the back of the Console and
attach the Console to the Mast.
NOTICE: Do not cut or pinch the cables.
13. Final Inspection
Inspect your machine to ensure that all hardware is tight and
components are properly assembled.
Do not use until the machine has been fully assembled and
inspected for correct performance in accordance with the
Owner's Manual.
41