Schwinn 170 Service Manual page 29

Note:
1.
Loosen and remove the screw (A) from the old Transport
Wheel assembly (B), and set it safely aside for reassembly.
Remove the old Transport Wheel assembly from the front
stabilizer (C), and discard.
2.
Install the replacement Transport Wheel assembly.
Note: Be sure the plastic alignment tab on the wheel
assembly goes into the slot (D) at the end of the
stabilizer tube.
3. Final Inspection
Inspect your machine to ensure that all hardware is tight and
components are properly assembled.
Do not use until the machine has been fully assembled and
inspected for correct performance in accordance with the
Owner's Manual.
A
29
C
B
D D