Schwinn 170 Service Manual page 44

6. Tie the length of string to the end (A) of the Data
Cable at the base of the Mast. Hold the other end of
the Data Cable (B) and carefully pull it out of the Mast
so that the string extends through the length of the
Mast. Untie the string from the old Data Cable and
discard the old cable.
NOTICE: Do not cut or pinch the HR cable (C).
7. Tie the end of the string at the base of the Mast to one
end of the replacement Data Cable. Hold the other end of
the string and carefully pull the new Data Cable through the
Mast.
NOTICE: Do not cut or pinch the cables.
8. Untie the string from the Data Cable and connect the
cable to the Data Cable from the Main Frame.
. NOTICE: Do not cut or pinch the cables. This step may
require two people.
9. Put the Mast back in position in the Main Frame and
reinstall the Hardware.
Note: Do not let the cables fall down inside the Mast.
NOTICE: Be sure not to cut or pinch any cables. This step
may require two people.
10. Slide the Top Shroud back into position and and reinstall
NOTICE: Be sure the tabs in the Top Shroud snap into
the Main Assembly.
11. Connect the cables to the back of the Console and
attach the Console to the Mast with the screws from Step 2.
NOTICE: Do not cut or pinch the cables.
12. Final Inspection
Inspect your machine to ensure that all hardware is tight and
components are properly assembled.
Do not use until the machine has been fully assembled and
inspected for correct performance in accordance with the
Owner's Manual.
B
C
44
A