Schwinn 170 Service Manual page 19

Hide thumbs Also See for 170:

Table of Contents

To adjust the Brake tension, loosen the 2 hex head bolts

point on the Brake Magnet (A) is within 3.0 mm (1/8") of the

Flywheel (B). Tighten the bolts.

Note: If the cardboard is not 3mm (1/8") thick, you can

use the pages of a paperback book to measure

the gap. Approximately 36 pages (sheets) = 3mm.

Turn the power on again. Use the console to check the

resistance adjustment.

Machine is on. Current is active. There is risk of electrical

shock.

Note: Before fully attaching the Shrouds, remove the

cardboard from between the Brake Magnet (A) and

the Flywheel (B). Power up the machine to verify

that the Magnet Arm can move freely, and that the

Brake Magnet and Flywheel do not touch.

Final Inspection

Inspect your machine to ensure that all hardware is tight and

components are properly assembled.

Do not use until the machine has been fully assembled and

inspected for correct performance in accordance with the

Owner's Manual.

Table of Contents

Show Quick Links

Table of Contents