Resetting The Switch; Reload The Configuration File - ZyXEL Communications XGS-4528F User Manual

6 Forget the password and/or IP address.
7 Prevent all services from accessing the Switch.
8 Change a service port number but forget it.
Be careful not to lock yourself and others out of the Switch. If you do lock
yourself out, try using out-of-band management (via the management port) to
configure the Switch.

4.6 Resetting the Switch

If you lock yourself (and others) from the Switch or forget the administrator password, you
will need to reload the factory-default configuration file or reset the Switch back to the factory
defaults.

4.6.1 Reload the Configuration File

Uploading the factory-default configuration file replaces the current configuration file with the
factory-default configuration file. This means that you will lose all previous configurations
and the speed of the console port will be reset to the default of 9600bps with 8 data bit, no
parity, one stop bit and flow control set to none. The password will also be reset to "1234" and
the IP address to 192.168.1.1.
To upload the configuration file, do the following:
1 Connect to the console port using a computer with terminal emulation software. See
Section 3.2 on page 46
2 Disconnect and reconnect the Switch's power to begin a session. When you reconnect
the Switch's power, you will see the initial screen.
3 When you see the message "
seconds ...
4 Type
atlc
5 Wait for the "
upload on your terminal.
6 After a configuration file upload, type
XGS-4528F User's Guide
for details.
Press any key to enter Debug Mode within 3
" press any key to enter debug mode.
after the "
Enter Debug Mode
Starting XMODEM upload
Chapter 4 The Web Configurator
" message.
" message before activating XMODEM
to restart the Switch.
atgo
59