Dhcp Snooping Vlan Configure; Figure 105 Dhcp Snooping Vlan Configure; Table 75 Dhcp Snooping Vlan Configure - ZyXEL Communications XGS-4528F User Manual

24.5.2 DHCP Snooping VLAN Configure

Use this screen to enable DHCP snooping on each VLAN and to specify whether or not the
Switch adds DHCP relay agent option 82 information
requests that the Switch relays to a DHCP server for each VLAN. To open this screen, click
Advanced Application > IP Source Guard > DHCP Snooping > Configure > VLAN.

Figure 105 DHCP Snooping VLAN Configure

The following table describes the labels in this screen.

Table 75 DHCP Snooping VLAN Configure

LABEL
Show VLAN
Start VID
End VID
Apply
VID
Enabled
Option82
Information
Apply
Cancel
XGS-4528F User's Guide
DESCRIPTION
Use this section to specify the VLANs you want to manage in the section
below.
Enter the lowest VLAN ID you want to manage in the section below.
Enter the highest VLAN ID you want to manage in the section below.
Click this to display the specified range of VLANs in the section below.
This field displays the VLAN ID of each VLAN in the range specified above.
If you configure the * VLAN, the settings are applied to all VLANs.
Select Yes to enable DHCP snooping on the VLAN. You still have to
enable DHCP snooping on the Switch and specify trusted ports.
Note: The Switch will drop all DHCP requests if you enable
DHCP snooping and there are no trusted ports.
Select this to have the Switch add the slot number, port number and VLAN
ID to DHCP requests that it broadcasts to the DHCP VLAN, if specified, or
VLAN. You can specify the DHCP VLAN in the DHCP Snooping
Configure screen. See Section 24.5 on page
Select this to have the Switch add the system name to DHCP requests that
it broadcasts to the DHCP VLAN, if specified, or VLAN. You can configure
the system name in the General Setup screen. See
You can specify the DHCP VLAN in the DHCP Snooping Configure
screen. See Section 24.5 on page
Click Apply to save your changes to the Switch's run-time memory. The
Switch loses these changes if it is turned off or loses power, so use the
Save link on the top navigation panel to save your changes to the non-
volatile memory when you are done configuring.
Click this to reset the values in this screen to their last-saved values.
Chapter 24 IP Source Guard
(Chapter 32 on page 259) to DHCP
210.
Chapter 7 on page
210.
73.
213