Port Vlan Trunking; Select The Vlan Type; Static Vlan; Figure 30 Port Vlan Trunking - ZyXEL Communications XGS-4528F User Manual

8.3 Port VLAN Trunking

Enable VLAN Trunking on a port to allow frames belonging to unknown VLAN groups to
pass through that port. This is useful if you want to set up VLAN groups on end devices
without having to configure the same VLAN groups on intermediary devices.
The following figure describes VLAN Trunking. Suppose you want to create VLAN groups 1
and 2 (V1 and V2) on devices A and B. Without VLAN Trunking, you must configure
VLAN groups 1 and 2 on all intermediary switches C, D and E; otherwise they will drop
frames with unknown VLAN group tags. However, with VLAN Trunking enabled on a
port(s) in each intermediary switch you only need to create VLAN groups in the end devices
(A and B). C, D and E automatically allow frames with VLAN group tags 1 and 2 (VLAN
groups that are unknown to those switches) to pass through their VLAN trunking port(s).

Figure 30 Port VLAN Trunking

8.4 Select the VLAN Type

Select a VLAN type in the Basic Setting > Switch Setup screen.

Figure 31 Switch Setup: Select VLAN Type

8.5 Static VLAN

Use a static VLAN to decide whether an incoming frame on a port should be
• sent to a VLAN group as normal depending on its VLAN tag.
• sent to a group whether it has a VLAN tag or not.
• blocked from a VLAN group regardless of its VLAN tag.
You can also tag all outgoing frames (that were previously untagged) from a port with the
specified VID.
XGS-4528F User's Guide
Chapter 8 VLAN
89