Configure Multiple Rapid Spanning Tree Protocol; Figure 54 Advanced Application > Spanning Tree Protocol > Mrstp; Table 29 Advanced Application > Spanning Tree Protocol > Mrstp - ZyXEL Communications XGS-4528F User Manual

Table 28 Advanced Application > Spanning Tree Protocol > Status: RSTP (continued)
LABEL
Topology
Changed Times
Time Since Last
Change

11.6 Configure Multiple Rapid Spanning Tree Protocol

To configure MRSTP, click MRSTP in the Advanced Application > Spanning Tree
Protocol screen. See
Figure 54 Advanced Application > Spanning Tree Protocol > MRSTP
The following table describes the labels in this screen.
Table 29 Advanced Application > Spanning Tree Protocol > MRSTP
LABEL
Status
Tree
Active
XGS-4528F User's Guide
DESCRIPTION
This is the number of times the spanning tree has been reconfigured.
This is the time since the spanning tree was last reconfigured.
Section 11.1 on page 107
DESCRIPTION
Click Status to display the MRSTP Status screen (see
This is a read only index number of the STP trees.
Select this check box to activate an STP tree. Clear this checkbox to disable an
STP tree.
Note: You must also activate Multiple Rapid Spanning Tree in the
Advanced Application > Spanning Tree Protocol >
Configuration screen to enable MRSTP on the Switch.
Chapter 11 Spanning Tree Protocol
for more information on MRSTP.
Figure 53 on page 116).
117