Configuring Vrrp Parameters; Figure 155 Ip Application > Vrrp Configuration > Vrrp Parameters; Table 108 Ip Application > Vrrp Configuration > Vrrp Parameters - ZyXEL Communications XGS-4528F User Manual

Figure 155 IP Application > VRRP Configuration > VRRP Parameters
The following table describes the labels in this screen.
Table 108 IP Application > VRRP Configuration > VRRP Parameters
LABEL
Active
Name
Network
Virtual Router ID
Advertisement
Interval
Preempt Mode
Priority
Uplink Gateway
Primary Virtual IP
Secondary Virtual IP
Add
Cancel
Clear

33.3.4 Configuring VRRP Parameters

View the VRRP configuration summary at the bottom of the screen.
XGS-4528F User's Guide
DESCRIPTION
Select this option to enable this VRRP entry.
Enter a descriptive name (up to 32 printable ASCII characters) for identification
purposes.
Select an IP domain to which this VRRP entry applies.
Select a virtual router number (1 to 7) for which this VRRP entry is created.
You can configure up to seven virtual routers for one network.
Specify the number of seconds between Hello message transmissions. The
default is 1.
Select this option to activate preempt mode.
Enter a number (between 1 and 254) to set the priority level. The bigger the
number, the higher the priority.
This field is 100 by default.
Enter the IP address of the uplink gateway in dotted decimal notation.
The Switch checks the link to the uplink gateway.
Enter the IP address of the primary virtual router in dotted decimal notation.
This field is optional. Enter the IP address of a secondary virtual router in
dotted decimal notation. This field is ignored when you enter 0.0.0.0.
Click Add to save your changes to the Switch's run-time memory. The Switch
loses these changes if it is turned off or loses power, so use the Save link on
the top navigation panel to save your changes to the non-volatile memory
when you are done configuring.
Click Cancel to discard all changes made in this table.
Click Clear to set the above fields back to the factory defaults.
Chapter 33 VRRP
271