16
SERVICE WORK ON THE ENGINE
16.3
Adding gear oil
Info
Too little gear oil or poor-quality gear oil results in premature wear to the transmission.
–
Start the engine and check that it is oil-tight.
Finishing work
–
Check the gear oil level. (
Preparatory work
–
Stand the motorcycle upright on a horizontal surface.
Main work
–
Remove screw
S01147-10
–
Remove filler plug
–
Add gear oil until it flows out of the hole of the gear oil level screw.
Engine oil (15W/50) (
–
Mount and tighten screw
Guideline
Screw, engine case
–
Mount and tighten filler plug
S01146-10
Danger
Danger of poisoning Exhaust gases are toxic and inhaling them may result
in unconsciousness and death.
–
–
–
Start the engine and check that it is oil-tight.
Finishing work
–
Check the gear oil level. (
p. 75)
.
.
p. 87)
.
.
Always make sure there is sufficient ventilation when running the
engine.
Use an effective exhaust extraction system when starting or running the
engine in an enclosed space.
p. 75)
M6x25
10 Nm (7.4 lbf ft)
76