11
SERVICE WORK ON THE CHASSIS
11.8
Installing the fork protector
11.9
Removing the lower triple clamp
–
Position the fork protection on the right fork leg. Mount and tighten screws
Guideline
Remaining screws, chassis
S01160-11
–
Position the fork protection on the left fork leg. Mount and tighten screws
Guideline
Remaining screws, chassis
–
Position the brake line and clamp. Mount and tighten screws
S01159-11
Preparatory work
–
Raise the motorcycle with the lift stand. (
–
Remove the front wheel.
–
Remove the fork legs.
–
Remove the start number plate. (
–
Remove the front fender. (
–
Remove the handlebar cushion.
Main work
–
Pull fuel tank breather
–
Remove nut
dlebar in an upward direction, and hang it to the side.
Info
Cover the components to protect them against damage.
Do not kink the cables and lines.
H01357-10
–
Remove protective ring
–
Take off the lower triple clamp with the steering stem in a downward direction.
–
Remove the upper steering head bearing.
H01358-10
(
p. 64)
(
p. 33)
p. 39)
p. 39)
out of the steering stem.
. Remove screw
, pull off the upper triple clamp with the han-
.
M6
10 Nm (7.4 lbf ft)
M6
10 Nm (7.4 lbf ft)
.
p. 32)
35
.
.