MAINTENANCE WORK ON CHASSIS AND ENGINE
Refilling with gear oil
x
11.106
Info
Too little gear oil or poor-quality oil results in premature wear of the transmission.
Adding gear oil
x
11.107
Info
Too little gear oil or poor-quality oil results in premature wear of the transmission.
The gear oil must be added when the engine is cold.
–
Remove screw cap
Gear oil
–
Mount and tighten the screw cap.
Danger
Danger of poisoning Exhaust gases are poisonous and inhaling them may
result in unconsciousness and/or death.
–
When running the engine, always make sure there is sufficient ventila-
tion, and do not start or run the engine in an enclosed space without an
B00053-10
effective exhaust extraction system.
–
Start the engine and check that it is oil-tight.
–
Check the gear oil level. (
–
Place the motorcycle on a level surface.
–
Remove gear oil level check screw
B00050-10
–
Remove screw cap
–
Add gear oil until it flows out of the hole of the gear oil level check screw.
Engine oil (15W/50) (
–
Mount and tighten the gear oil level check screw.
Guideline
Screw, gear oil level check
–
Mount and tighten screw cap
B00053-11
Danger
Danger of poisoning Exhaust gases are poisonous and inhaling them may
result in unconsciousness and/or death.
–
When running the engine, always make sure there is sufficient ventila-
tion, and do not start or run the engine in an enclosed space without an
effective exhaust extraction system.
–
Start the engine and check that it is oil-tight.
and fill up gear oil.
0.70 l (0.74 qt.)
Engine oil (15W/50) (
p. 76)
.
.
p. 96)
M6
.
78
p. 96)
10 Nm (7.4 lbf ft)