11
SERVICE WORK ON THE CHASSIS
11.38
Checking the frame
–
Check the chain sliding piece for wear.
»
If the lower edge of the chain pins is in line with or below the chain sliding
piece:
–
Change the chain sliding piece.
–
Check the chain sliding piece for tightness.
»
If the chain sliding piece is loose:
–
Tighten the screw on the chain sliding piece.
Guideline
Screw, chain sliding piece
H01379-10
–
Check the chain guide for wear.
Info
Wear can be seen on the front of the chain guide.
»
If the light part of the chain guide is worn:
–
Change the chain guide.
401760-01
–
Check the chain guide for tightness.
»
If the chain guide is loose:
–
Tighten the screws on the chain guide.
Guideline
Remaining screws, chassis
H01380-01
Finishing work
–
Remove the motorcycle from the lift stand. (
–
Check the frame for cracks and deformation.
»
If the frame exhibits cracks or deformation due to a mechanical impact:
–
Change the frame.
401542-01
Info
Always replace a frame that has been damaged due to a mechanical
impact. Repair of the frame is not authorized by KTM.
M8
15 Nm
(11.1 lbf ft)
M6
10 Nm
(7.4 lbf ft)
p. 32)
49